[ATrpms-users] Problems with IVTV after FC4 Upgrade

[Mark Prinz]

This may be a question for the IVTV list but I figured I would start
here. I did an FC3 to FC4 upgrade via the CDs, upgraded the main
MythTV supporting software but I cannot get IVTV to load.

When I run '/sbin/depmod -a' and '/sbin/modprobe ivtv' nothing
happens. and '/bin/dmesg/ |grep Init' shows nothing for ivtv.

Also, there is no /dev/video* directories

If I run, 'sbin/lspci -v' I get:
03:04.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
        Subsystem: Hauppauge computer works Inc. WinTV PVR 250
        Flags: bus master, medium devsel, latency 64, IRQ 16
        Memory at e8000000 (32-bit, prefetchable) [size=64M]
        Capabilities: [44] Power Management version 2

I had to manually install the RPMs from Atrpms.net but I think I have
them correct:

[mythtv at localhost ~]$ rpm -qa|grep ivtv
ivtv-firmware-enc-2.04.024-9.at
ivtv-kmdl-2.6.16-1.2111_1.rhfc4.cubbi_swsusp2smp-0.6.2-110.rhfc4.at
perl-Video-ivtv-0.13-7.rhfc3.at
ivtv-firmware-audio-0.0.1-5.at
ivtv-firmware-dec-2.02.023-9.at
ivtv-0.6.2-110.rhfc4.at
ivtv-firmware-1.8a-9.at

And here is my kernel:
[mythtv at localhost ~]$ uname -r
2.6.16-1.2111_1.rhfc4.cubbi_swsusp2smp

Any suggestions?

Thanks!